Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: KA3DCO on 2018-05-04, 02:12:05

Title: IC-7100 and straight key
Post by: KA3DCO on 2018-05-04, 02:12:05

I am remoting an IC-7100 very successfully with the RRC 1258 MKII - I have no problem using a paddle connected to PAD jack on rear of RRC control unit - is there a means to use a straight key with this setup? I previously used the IC-706 MKII G and the key was connected to the mic jack on the 706 control head - Kenny, KA3DCO

Title: Re: IC-7100 and straight key
Post by: dj0qn on 2018-05-04, 02:53:33

You will find instructions in the RemoteRig manual, pages 94-95 & Appendix B.

An external keyer interfaces as a straight key, so a straight key could be used in place of a keyer.

73,
Mitch DJ0QN / K7DX