Messages

1

General discussion forum / Webswitch Rotator control

« on: 2013-05-07, 19:07:16 »

My new Webswitch 1216H ver 002, firmware 3.1, bootloader 1.10, hw 002 does not show a "rotator control" item just under "Dynamic DNS settings as does the instruction page http://www.webswitch.se/wp/?page_id=530
I need help setting up my webswitch for use with the 1216L
Thanks, Jim

2

Hardware, Cabling, Installations / Rotator control with webswitch 1216H

« on: 2013-05-07, 18:38:16 »

With 1216H WebSwitch software 3.1, Hardware 2 my webpage does not show "rotator settings" under Dynamic DNS settings as does the ( http://www.remoterig.com/wp/?page_id=840 ) instructions. So how do I get this on my 1216H webpage?

3

General discussion forum / New member

« on: 2013-04-25, 21:32:42 »

I've been looking for an online manual maybe with some pictures to hook up my LAN to webswitch 1216H to rotocard 1216L. I've read the 1216H & L "setup" on the page but its lacking in a lot of detail.
and mount in an existing or hook-up to a Ham-M rotor control for a Tailtwister Rotator.
Tnx, jim

4

General discussion forum / wireless access for RCC1258 and 1216H

« on: 2012-09-08, 00:33:45 »

Any suggestions for connecting these devices to a wireless router?

5

General discussion forum / USING remote rig to control power & access.

« on: 2012-09-08, 00:30:46 »

I have a pair of K3 RRC-1258 MkII.  Now I want to be able to remove/apply power for the station remotely as well as run a rotator and steppir antenna. Any suggestions or diagrams. Which would be a better approach ie to get a RRC 1216H or 1216 Webswitch. Or is there any difference? I believe I have one comm port left on the RCC 1258 to perhaps power a relay for station power. Has anyone done this?   TIA,  Jim