Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: DM1CG on 2009-12-25, 14:57:02

Title: connection RS232
Post by: DM1CG on 2009-12-25, 14:57:02

HY all

searching a solution to make a connect from my PC over RRC-1258 to my TS-2000.

MODE 4 / 9600 / 8 / 1 / N . Also connectet PIN 7 to PIN 8  at radio side

My ARPC program didnt get a connect to the TS2000.

The connection from RC2000 to TS2000 runs with no problem.

any idea

best 73 de Carsten

Title: Re: connection RS232
Post by: DM1CG on 2009-12-30, 22:32:49

Hy all

i found the RS232 with helpfully tips from Mikael.

so i do now:
PC -> 1:1 -> Unit Controller --- NET --- Unit Radio -> crossover (with connected 7 / 8) -> TS2000
(strange was that i must set one time RTS high on the Radio-Unit)

At the moment the RS232 is only opened if the TS2000 is switched on bei RC2000.

Now i search the solution to controll the TS2000 without RC2000 . only by ARCP Software or HRD.

HNY all de Carsten
DM1CG