Remote Rig

Webswitch 1216H Support in English => General discussion forum => Topic started by: ei4ghb on 2012-01-31, 21:40:28

Title: Rotator help/advice???
Post by: ei4ghb on 2012-01-31, 21:40:28

Hi everyone,
Im after buying a remoterig for my TS2000 Kenwood. I'm looking at the best option for a remote rotator system.
I need to control two yagis, one for UHF and one for VHF, so I dont need a large powerfull rotator.

I'm thinking of using a Yaesu G450. Has anyone successfully interfaced this to the webswitch?
Or maybe someone could suggest a similar low cost option.

Thanks in advance!!

Tony

EI4GHB

Title: Re: Rotator help/advice???
Post by: ON4AOI on 2012-02-02, 18:44:32

I installed the microbit board inside the controller,
its working OK but because the voltage is very low
the read out is not 100% all the time but good enough

Guy ON4AOI

Title: Re: Rotator help/advice???
Post by: ei4ghb on 2012-02-02, 18:46:44

Hi there Guy,
Thank for replying. Where can I find documentation on doing this?

Tony

Title: Re: Rotator help/advice???
Post by: ON4AOI on 2012-02-07, 15:03:17

There is no documentation, you can figure this out easy with your manual and the connection diagram from the
microbit board

Guy ON4AOi