Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: W0CP on 2013-11-06, 17:02:13

Title: PTT switches local from USB to CW
Post by: W0CP on 2013-11-06, 17:02:13

Just installed k3 with k3/0.  Front panel PTT switches local from USB to cw mode (remote stays in USB). When I release PTT, local goes back to usb mode. If I press XMIT on front panel instead of mike PTT, local stays in USB mode. Checked all wiring and config settings. I am out of ideas. Any suggestions?

73, Walt

Title: Re: PTT switches local from USB to CW
Post by: sm2o on 2013-11-07, 08:21:10

Hi, Never heard about something like that before, Check with Brandon at Elecraft.

/mike

Title: Re: PTT switches local from USB to CW
Post by: W0CP on 2013-11-13, 16:24:27

Talked to Elecraft. It's a known issue which will be addressed someday. It's a display glitch on the local which does not affect operation.

Title: Re: PTT switches local from USB to CW
Post by: VE6SH on 2013-11-14, 15:00:22

Walt, yes, it is a know issue. My set up does the same.

Good to see you on here.

73

Tim VE6SH