Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Paul_K9NU on 2016-02-04, 16:27:40
-
My RemoteRig boxes with the K3 had been working fine for several days but now had developed a problem at the Radio end. I cannot connect to it. I can ping the 192.168.1.170 IP using Team Viewer looking at my home computer and get a normal response back. I also can see the RemoteRig box connected to my home router. The Microbit setup manager shows "device disconnected". I cycled the power to the box via my IP power switch with no luck. Any Ideas?
73 Paul K9NU
-
Paul
ur problem sounds similiar to mine. My K3 mini /K3 remote has been working for several months. over past week have had many occaisions when k3 will not turn ON....also have had the K3 turn OFF by itself in the middle of operating it. I can cycle the AC power on the RR Boxes and also the remote K3 PS an Astron 35 and most times the K3 will turn ON but sometimes not.
Still at a loss as to what is wrong. I read a few online posts on Elecraft reflector about the Astron 35 amp suppply and others having issues with the K3 turning OFF...have another supply here which i will try but didn't want to use it as it is a switching supply .
THe K3 turns on by a ground being place on pin 8 of the ACC socket. I have reseated the ACC plugs while at the site and also reseated all the connections to the RR box....
Also i have discovered there is packet loss happening on my internet line...this could impact the problem ... if there are periods of high error rate on the line that can cause interruption of data flow...the RR box can sense this and send a command to the K3 to go OFF line.
Problem still persists and is ongoing as I type
FRank VO1HP
-
Thanks for the info, Frank. I am up and running with Brandon's help at Elecraft. Rebooted my router and seems to be working fine now.
73,
Paul, K9NU