Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: K0PC on 2016-04-05, 04:44:55

Title: Paddle stops working when N1MM is running
Post by: K0PC on 2016-04-05, 04:44:55

I have a K3 Twin setup that is working well with N1MM+ for logging. I am using the built in WinKeyer on COMExtra and it works fine for sending the function key messages but the paddle doesn't work. If I shut down N1MM+ then the paddle works as expected. Restart N1MM+ and the paddle is useless again.

I haven't used the remote setup in a while but I believe it used to work correctly. I am running the version 2.90 firmware.

Does anyone have any ideas where I should look?

Thanks,
Pat KØPC