Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: Michael on 2010-12-13, 00:10:28

Title: Solved 2 issues, one left
Post by: Michael on 2010-12-13, 00:10:28

Good evening all:

Well hopefully my next posting will enlighten me like my previous post! LOL
I managed to get my audio to and from the rig, control the rig with HRD and key the rig's PTT with my desk mic connected to the Control RRC.
With my wife speaking in the mic, I heard her through my headphones, connected to the rig's headphones jack with the monitor activated.  (Ossim)
Now if I could get the CW operation working. I don't know where to go from here.
I have set my rig up for straight key operation but nothing's happening when I activate my paddles, just the side tone in the control RRC.
Any advice?

Thanks all & 73:

Michael

P S
Had to use the forced -3 parameter in the control RRC's serial settings. 
Also, rig is Yaesu FT-450

Title: Re: Solved 2 issues, one left
Post by: sm2o on 2010-12-13, 07:58:39

If you have sidetone you have activated the keyer. So the only thing left is to decide which output you want to use for the keying signal. Go to the IO page in the Radio-RRC. There you kan select which output you will use, easiest is to activate keyer on all 3 to start with.

73 de mikael