Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: IU0PCX on 2023-09-15, 22:58:26
-
Hello everybody.
I connected a cw straight key by an RJ45 to the controller box. I did all the seetings as in the manual, now the situation is:
I switch in a cw mode in the radio, i can hear my cw tones without the possibility to low their volume and the radio DO NOT TX when I digit.
Do i miss some other cable link in the remote rig radio box I have on my qth site?
Thanks, Antonio.
-
Hi
In the Radio-RRC you have to setup one output to "Keyer" and connect the corresponing output to the Radio stright key input. Normally out2 is used if you connect a standard 3.5 mm audiocable from the PAD jack to the radio
73 de mike
-
Ok, non was helpful than my voluntee to try, anyway thanks to everybody.
Here full explaination of what I did to make my STRAIGHT CW KEY work on my IC 706 MK2G:
IO SETTINGS CONTROLLER BROWSER PAGE:
IN0=KEYER
OUT0= KEYER
OUT1= I/O
OUT2=I/O
USB RST= DISABLED
USB DTR= DISANLED
-----------------------------------------------------
IO SETTINGS RADIO BROWSER PAGE
OUT0=KEYER
OUT0 ON/OFF=ON
OUT1= I/O
OUT2= I/O
-------------------------------------------------------
KEYER SETTINGS CONTROLLER BROWSER PAGE
ENABLE=YES
IAMBIC= OLD TYPE
PAD REVERSE= NO
*other voices as "default", see user manual.
--------------------------------------------------------
KEYER SETTINGS RADIO BROWSER PAGE
PTT ACTIVATED BY KEYER=YES
--------------------------------------------------------
CONNECTION STRAIGHT KEY - RJ45 568B version - CONTROLLER:
Connect blue cable and brown cable of RJ45 to key poles.
--------------------------------------------------------
CONNECTION REMOTERIG "RADIO BOX" - RJ45 568B version - JACK - CW STRAIGHT KEY IMPUT ON IC 706:
Connect brown cable to jack's negative pole, connect blue&white cable with jack's positive pole.
---------------------------------------------------------
IC 706 MK2G MENU SETTINGS:
Q4 page: CW PADDLE, select OFF.
These are my settings and it works so good!
7351 to all!