Remote Rig

RRC 1258 Support på Svenska => Allmänt diskussionsforum => Topic started by: SA0TJS on 2024-10-10, 12:47:01

Title: Remoterig Kenwood TS480 through mobile router TPlink Archer MR600
Post by: SA0TJS on 2024-10-10, 12:47:01

Hi!

I am trying to set up remote rig  according to the above configuration. All seems to be set up correctly.  The ddns information is recognized by the controller (panel) side, i.e. the host address is shown in the status information on the controller!

So the LAN/network should be Ok but still the communication  between the controller and the host (radio) is not working. When I press the power button a peep sounds after a while. I have checked the SIP passwords, they are equal.

When i connect the controller directly to the tp-link router (to same LAN as the radio) it works ok.


What more can I do/check.

73 de Björn

Title: Re: Remoterig Kenwood TS480 through mobile router TPlink Archer MR600
Post by: sm2o on 2024-10-10, 12:52:09

Har du kollat att du inte har CGNAT?
http://www.remoterig.com/wp/?page_id=3494

73 de micke

Title: Re: Remoterig Kenwood TS480 through mobile router TPlink Archer MR600
Post by: SA0TJS on 2024-10-10, 13:32:12

Hej,

Tack för återkopplingen! Ska kolla. ISP = Telenor.

/B

Title: Re: Remoterig Kenwood TS480 through mobile router TPlink Archer MR600
Post by: SA0TJS on 2024-10-10, 13:57:33

Hej igen,

Routern har fått samma adress från ISP som whatsmyip.org visar (178.31.xx.xxx ), så tycks inte vara det som är problemet..
/B

Title: Re: Remoterig Kenwood TS480 through mobile router TPlink Archer MR600
Post by: sm2o on 2024-10-10, 14:00:09

bra början, då kan du ta ut export settings(html) filer från bägge boxarna och maila till support@remoterig@com så får jag kika på dem

/micke