Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: Mel KJ9C on 2025-04-28, 19:13:10

Title: Ethernet connection dead
Post by: Mel KJ9C on 2025-04-28, 19:13:10

Radio RRC1258MkII went down 2 weeks ago. Troubleshooting via Teamviewer could not help.
Now at the radio site 1600 miles from control site. USB connection shows all is OK using Microbit setup interface to PC. Yellow/red lights are off, front green light is blinking slowly, Ethernet light on rear is steady yellow awaiting connection. LAN settings all agree (IP, subnet mask, etc) but the network does not see the RRC and therefore won't connect.
What to try next?

Title: Re: Ethernet connection dead
Post by: DL6RDM on 2025-05-08, 07:28:29

Hello Mel,

I had the same problem more times with the same RRC from a friend.

Please read this post, (especial the last message) maybe it helps you:
https://www.remoterig.com/forum/index.php?topic=7272.msg33500#msg33500

Best way is to start this way I guess...

73s,

Christian

Title: Re: Ethernet connection dead
Post by: Mel KJ9C on 2025-05-12, 01:43:14

I contacted Microbit and, after a few attempts at access, the prognosis was a bad Ethernet board. A new one is on the way. (cost 170 USD)+