Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: UR5FLN on 2025-08-05, 22:26:48

Title: TS480 SAT 95% no Audio via RRC boxes
Post by: UR5FLN on 2025-08-05, 22:26:48

Dear friends,
Today I was busy with setup my RemoteRig with TS-480 SAT and faced issue - everything seems to be OK, I was able to start my Kenwood through remoterig boxes, but only issue no RX/TX sound. I would say that may be in 5 % cases it have started normally with sound both ways. I have 2 pairs of RemoteRig and replaced and setup each side, but result is the same. So this is not hardware issue. Did somebody fight with same? I use on the radio side 4G router with wireguard connection to droplet with external fixed IP with all ports forwarded. Strange thing is that it's sometimes working, sometimes not. All settings according to manual, I played with codecs bandwidth, levels, but still no success. Thanks for any ideas, advices.

73!
de UR5FLN
Sergy

Title: Re: TS480 SAT 95% no Audio via RRC boxes
Post by: sm2o on 2025-08-06, 07:56:59

Hi
I'm sure this problem is caused by your internet connections. Default settings should work. Start from testing both units on the same LAN to verify hardware, cables and basic settings.

73 de mike

Title: Re: TS480 SAT 95% no Audio via RRC boxes
Post by: UR5FLN on 2025-08-06, 09:53:05

Hello Mike,
thanks for advice, I have my suspicions also, regarding internet connection. I will double check and revert.

Sergiy
UR5FLN

Title: Re: TS480 SAT 95% no Audio via RRC boxes
Post by: UR5FLN on 2025-08-06, 10:25:06

Yeap, Evrika!)) That was internet connection, swaped to LAN and all works as it should. Then I changed ports it was 9068-9070 (I do not know why, probably I did some tests before) to 13xxx and it started work via 4G and for now looks all fine, I have sound both RX and TX. So problem was in strange 90xx ports, reason for me unknown. Hope info will be handy for everyone.

Thanks
Sergiy
UR5FLN