Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Mitch on 2026-03-22, 15:42:12
-
Hi there can anyone help me out regarding audio problem between RRC boxe's. I have not worked my Kenwood 480 for some time now. Face and radio side work fine but problem with audio remote.
I have installed it again with same setting's but for some reason there is no incoming audio. I can see both control side at home OK and radio side at remote side fine. I am not sure if maybe it has changed and this could be my problem.
Any help would be grateful to get me online again,
73s Gary
-
After looking into Radio, status page it show
SIP Out port 13000
SIP In port 13000
Audio Out port 1198
Audio In port 13001
Command Out port 62758
Command In port 13002
External SIP In port 13000
External Audio In port 13001
External Cmd In port 13002
In a old image pictures of radio and control side that worked OK. Both radio and the control side settings are a correct copy as before that worked great.
Radio turns on fine but still can't get no Audio from the Kenwood 480 remote. Tried this with both my 480 HX and Sat version.
-
Hi Gary
have a look at
https://www.qsl.net/hb9bjl/
and check the ports and the forwarding of both radio and control units on your router.
My setup works fine.
I have posted some screenshots for the TS-480 setup.
What is your callsign ?
73 de Christian
HB9BJL
W9BJL
-
Hi Christian
Thank you for your reply, I did notice your post and followed Radio side and control. All port forwarding looks Ok within router and connects fine just audio and power.
Also had a look and rewired the jumpers within both boxes hoping it maybe this was causing the problem with no joy yet.
Hope to try get back to the radio sode when i get home over the weekend. Again many thanks for your help.
73 Gary