Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: SM0SHG on 2011-09-04, 09:33:00

Title: Power-up issue with TM-D710
Post by: SM0SHG on 2011-09-04, 09:33:00
Hi all,

I'm using the RRC's to operate a TM-D710. It works great. But every now and then, the display wont power-up properly when I push the "on" button. I get the "roger beep", but the display stays dark and no info is visible. The quick fix is to reset the local RRC box by killing the power. Then it works great again for a few times. This might happen every fourth or fifth time I try to turn it on.

I'm using the latest FW...

Any suggestions what I could do?

Regards,
Adde
Title: Re: Power-up issue with TM-D710
Post by: Jan (Microbit) on 2011-09-05, 08:31:00
Does it make any difference if you keep the on button pressed a little longer?
Title: Re: Power-up issue with TM-D710
Post by: SM0SHG on 2011-09-05, 17:57:08
Will try. Is this a known bug?
Adde
Title: Re: Power-up issue with TM-D710
Post by: Jan (Microbit) on 2011-09-05, 20:34:24
Will try. Is this a known bug?
Adde

Not a bug in the RRC, but a behaviour some radios have.
Title: Re: Power-up issue with TM-D710
Post by: SM0SHG on 2011-09-05, 20:45:59
ok... Have tried a few times now and it works 100%. Will let you know if it does not :)
Adde
Title: Re: Power-up issue with TM-D710
Post by: kc9nsa on 2011-09-26, 05:31:59
I have the same issue every once in a while with the TM-D710A.  I usually power off/unplug the RRC-Control and let it sit for 2 minutes and the plug it back and its fine.  I figured it was a connection issue, glad to hear it's not the RRC boxes.

73's
Mike-KC9NSA
Title: Re: Power-up issue with TM-D710
Post by: sm2o on 2011-09-26, 17:35:27
Hi

I use TM-D710 my self. I have also seen that if the disconnection is caused by Internet failure, then you can get in trouble when trying to connect from the button. A reboot of the Radio-RRC can be needed. We will look in to that when we get time. I don't think it's a mayor issue.

73 de mike