Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: w6duo on 2011-10-21, 20:12:08
-
The units were setup and used one year ago and then deactivated. Upon reactivation i reset all units to default. I change the IP's to match my home network IP as noted in the instructions. I am able to get into the units via web interface as mentioned in the instructions. However when i try to get the units to talk to each other i get no activation of the ts-480 and get the blinking yellow light denoting SIP failure. I also get the alarm tone from the control head.
When i use the default IP's on the units they communicate and i can activate the 480 with all functions operating normally.
What simple step am i missing here. HELP
-
Did you also change "SIP contact" in the control RRC to match the IP of the radio RRC? Which firmware version are you on?
-
Thanks Jan, later on i did read a post regarding setting the sip contact. I changed that and it worked great. Did i miss that in the instructions? I spent a few hours trying. So far so good.
thanks
Don