Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: n0xbd on 2011-11-10, 15:47:01
-
I am doing the initial setup and test of the RRC-1258MkIIs connecting it to a TS-2000x along with the RC-2000.
The RRC-1258s are both running V2.46 firmware. I have them both hooked together on our local network, connected to the same switch. My problem is, I cannot get the RC-2000 to turn on. When I press the power button on it I get nothing, but if I power on the TS-2000 I get PTT and both recieve and transmit audio to pass through the network, and I also can get Ham Radio Deluxe to work over com2. I followed all of the procedures in the book as far as jumpers and baudrates are concerned. Has anyone else run into this?
Any help would be much appreciated.
Chris Bolton
N0XBD
-
Nevermind, found a cabling problem. Everything is working fine now.