Remote Rig
RRC-Micro PC Client in English => General discussion => Topic started by: PY1KN on 2011-12-01, 02:48:16
-
Mike and friends
I have been using the standard setup with 2 RRCs for months now, with success. Additionally, I have Com2 connected to the radio with a straight serial cable, and I can control the radio with either DX4WIN or Win-Test.
Now I decided to add a RRC-Micro PC to use on the road. I've just installed it, and I can get the SIP connected, the buffer bar moves, but there is no sound at all.
When I start HRD, I configure the Com port to the virtual pair of Com2, the software connects but when it comes to read the radio frequency, it fails.
I read somewhere in this forum that I might need to tie pins 7 and 8 at the radio port in order to get it working. Is that the case? If so, why does my cable works with the standard configuration + Win-Test and not with the Micro-PC + HRD?
Marcelo, PY1KN
-
Yes if jmp3 is in place and you use a straight cable with wies fro pin 2,3,5,7,8 then pin 7 and 8 will be connected together in the RRC.
73 de mike
-
Hi Mike
Thank you for the answer. IŽve just checked my photos, jumper 3 is in place on both RRCs. So I guess the problem is not the connection between Radio RRC and the TS480.
IŽll investigate elsewere, maybe Micro-PC Client configuration or the virtual ports.
73
Marcelo, PY1KN
-
Solved!
I reinstalled all software and reconfigured, all is OK now. I mus have had something wrong in the port settings. Now HRD works great, though I`d rather use TRX-Manager.
Thank you
Marcelo, PY1KN