Remote Rig
RRC 1258 Support in English => Hardware, Cabling, Installations => Topic started by: ea7rm on 2012-02-04, 11:45:51
-
Hola to all,
Managed to setup Alfaspid rotor via COM2 sucesfully but since i need COM2 for CAT control and cw keying via PC i tried to change ALfaspid to COM1, but everytime i plug the connector into COM1 of RRC-1258 box the rotor start to move to left side. i´m using the same wire as worked with COM2.
Any suggestion ?
Thanks in advance
73s, Nino EA7RM
-
Hi Nino,
COM1 and COM2 are backwards, so you will need to reverse the wires. Look
again at the manual.
73,
Mitch DJ0QN / K7DX