Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: DM1CG on 2010-01-16, 23:57:45

Title: Problem - DHCP and RRC Manager
Post by: DM1CG on 2010-01-16, 23:57:45

Hello all

with RRC Manager i didnt can get a connection to the control unit
if the unit do DHCP.

What is the way to config the unit ?

vy 73 de Carsten

Title: Re: Problem - DHCP and RRC Manager
Post by: sm2o on 2010-01-17, 00:04:35

Hi

You have to explain more about your problem. RRC-manager uses the USB connection is independent of DHCP.

73 de mike

Title: Re: Problem - DHCP and RRC Manager
Post by: DM1CG on 2010-01-17, 11:50:25

Hello Mike

I set the unit to DHCP and reboot them.

If i have no DHCP Server and the unit get no IP Adresse i didnt can connect
the unit via the RRC USB connection.

The RRC Manager shows RRC connected, but when i will get the SETUP
i get no answer from the RRC.

best 73 de Carsten

Title: Re: Problem - DHCP and RRC Manager
Post by: sm2o on 2010-01-17, 11:59:02

Hi

I have tested that several times and the RRC manager works 100% even if the PWR LED is flashing because the network contact is missing.

73 de mike

Title: Re: Problem - DHCP and RRC Manager
Post by: DM1CG on 2010-01-17, 12:34:33

Hello

RRC have 100% connect on the LAN over a switch !

But if i didnt get an IP adress the PWR LED is flashing.
IF i have no iP adress i didnt can connect the RRC via USB.

What is my way to change the IP settings from DHCP back
to an static IP ?

directly if i start the dhcp server - the PWR LED stoped flasching
(Unit get an IP) and i can connect via RRC Manager

best 73 de Carsten

Title: Re: Problem - DHCP and RRC Manager
Post by: e72x on 2010-02-06, 21:29:00

Hi,

Try this,  pressing and keep the button pressed for 20 sec the unit reset to factory default settings..
On this way you will get default static Ip address  192.168.0.227 (control) and 192.168.0.228 (radio) side..

73,

e72x - Gordan