Remote Rig

RRC 1258 Support in English => Hardware, Cabling, Installations => Topic started by: KB7Q on 2012-04-25, 23:26:30

Title: Com Port 1 - ready to tackle
Post by: KB7Q on 2012-04-25, 23:26:30

I'm trying to get clear on how COM1 is wired, so I can add the next control feature to my set of Remoterig boxes which I'm hoping to be control of a Elecraft KPA500 amp with their utility program.

I think I understand the radio side box is wired so the cable to connect to a device should be:
pin2 ---> pin3
pin3 ---> pin2
pin5 ---> pin5
Yes?
So is COM1 on the control side box wired also like above or straight thru like COM2?
Thanks,
Gene, KB7Q

Title: Re: Com Port 1 - ready to tackle
Post by: sm2o on 2012-04-26, 07:33:21

There is a instruction and cable drawings on the website.

http://www.remoterig.com/wp/?page_id=426

pin config for the com port connectors are shown in the users manual

73 de mike

Title: Re: Com Port 1 - ready to tackle
Post by: KB7Q on 2012-04-26, 08:19:32

Thanks Mike, I found the pin out drawings this afternoon.
Gene