Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: W1UE on 2012-09-04, 14:38:15
-
Going over the documentation, I see that I can add computer keying to the Control unit by making up a jumper to the I/O port.
The computer keying would be through N1MM Logger to a Winkey, and would take Pin 4 of the I/O port to ground at Pin 8 when the rig was being keyed.
Is there anyway to change the configuration to use the paddle jack to do the same? Is there anyway to do computer keying without adding the additional cable?
Dennis W1UE
-
Hi
Yes you can configure the USB interface to be used for keying, See I/O settings in the Control-RRC
73 de mike