Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: 4Z4OQ on 2012-10-26, 10:43:50
-
Hi
i am installing easyrotor via com1 - what should be the mode setting at control side and radion side
Thanks
4z4oq
-
HI,
For my ERC I use COM 2, Mode 3, 9600. Cabeling like: http://www.remoterig.com/old/schema/prosistel-1a.pdf. Connections on radioside is the same as Pro Sis Tel rotor.
Wiring the 3,5 mm plug look at ERC-manual: PIN 3 = TXD, PIN 2 = RXD, PIN 5+7 = GND
73
Willi
-
i am using old cde ham 4. without remoterig direct connection all worked ok in 4800 but cant make it run with rrc
-
HI,
For CDE-Rotors e.g. you need a special interface by ERC: http://schmidt-alba.de/eshop/product_info.php?products_id=24
73
Willi
-
this is what i got.... i am looking to know the mode setting of com1 of the rrc at both ends
-
Serial settings:
Control:
COM2 mode Mode-3, char-timeout
COM2 baudrate 4800 (Rotor 1xAZ), 9600 (Rotor 2x AZ)
COM2 data bits 8
COM2 stop bits 1
COM2 parity 0 - Off
COM2 terminator (hex) 00
Use USB Com Port as COM2 No
Radio:
COM2 mode Mode-3, char-timeout
COM2 baudrate 4800 (Rotor 1x AZ, 9600 (Rotor 2xAZ)
COM2 data bits 8
COM2 stop bits 1
COM2 parity 0 - Off "
COM2 terminator (hex) 00
For baud look at your ERC-Manual
73 Willi
-
thanks willi. however my com2 is CAT control and i am looking to control the rotor via com1... are setting the same?
-
Hallo,
Yes setting is the same.
Cabeling: http://www.remoterig.com/old/schema/prosistel-1a.pdf
Look for rotor COM1 to forum: search, rotor COM1, especially: http://www.remoterig.com/forum/index.php?topic=1557.msg6595#msg6595
gd success
Willi