Remote Rig

Webswitch 1216H Support in English => General discussion forum => Topic started by: iw1gap on 2012-11-13, 23:33:56

Title: RRC-1258 Firmware 2.65 V7
Post by: iw1gap on 2012-11-13, 23:33:56

Hello,
I find it really strange that:
my device RRC Radio MkII can not communicate with RRC-Control V7.
There is a minimum compatibility between the two terminals?
The error that appears is:
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error

the doors, on firewall, are open, the cable for ic2820 is ok (i13a).
Any ideas please?

thanks
Andrea

Title: Re: RRC-1258 Firmware 2.65 V7
Post by: la8jra on 2012-12-08, 14:31:54

Have the same problem (IC-E2820). I have not tested lower versions of firmware, but i will try to downgrade.
Another detail is that the green light (back light in buttons) in the mic is turning on and off.

The radio will not turn on, and the following messages are comming on the telnet port from the controll unit, but noting is happening on the telent port for the Radio unit.


CP-> Panel power off due to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off due to no comm.
CP-> Panel power on after SIP error

Hope for som hints!

Thanks