Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: va3mw on 2013-05-26, 15:22:24
-
I am using the latest RRC Micro, and it doesn't seem to retain mic gain settings.
Everytime I start it, the mic gain is in the middle. My normal setting is at about 20%. Is there anyway to have it remember the settings. This is becoming a problem as the application keeps crashing (more on this later), and when I restart it, my mic gains are off.
Also, is there anyway to change audio sources (speakers especially) while connected. When monitoring HF, I am on the speakers. When on the air, I switch to headphones. However, this requires me to disconnect, change the source and then reconnect. As an example, Skype allows me to do this on the fly.
I really don't want to set up Virtual Audio Cable to handle the audio streams if I don't have to.
Mike va3mw
-
Mike,
Not sure if this will solve your problem, but there is a program available that fixes the
audio card and audio levels used per program.
It is called the "Romac Sound Card Manager" and can be downloaded at:
http://www.romacsoftware.com/
73,
Mitch DJ0QN / K7DX
-
I will look into saving and restoring gain values of the mic & speaker levels
-
Thanks Roland
I'm really trying to use this device more often as it is more convenient as I travel.
If there is anything you wish me to test, that would be great.
Being able to change audio sources on the fly would be nice as well as I often monitor 6M and then put the headphones on when it opens.
73
-
I will check what's possible