Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: Fred VE3PIE on 2013-08-14, 22:07:30
-
configuring the yaesu twins, with a computer at the control site using MMTTY.
Not sure how to configure COM 1 and COM 2 at the Control RRC and the Radio RRC.
In the serial settings setup: is both COM 1 and COM 2 set to Mode 6 at the Control and Radio RRC's ??
or is it set differently ?
please help anyone ?
thanks, Fred VE3PIE
-
Fred,
Fred,
Just follow instructions in the manual to set COM0 to 38400 and the radio to mode-10.
By setting the RRC's to mode-10, COM 2 is automatically set to "logical parallel with COM0",
you don't need to make any further COM port settings.
If you want to use CAT, you need to set COM1 to mode-6 and use that to pull CAT off of
the RRC. This is because the two rigs are blocking COM2 for communications between them.
73,
Mitch DJ0QN / K7DX
-
Hi Mitch, or anyone else...
Let me see if I have this straight This is all new to me:
To use yaesu twin setup with computer attached to control RRC for MMTTY and for logging program like HRD or TRX manager or DX4WIN
Control RRC settings:
Control radio: 38400 baud and program mode 10
Use USB Com Port as COM0 --> yes or no ????
Control RRC serial settings: COM1 mode: mode-6, CAT to COM2 (local)
Use USB Com Port as COM1 --> yes or no ???
COM2 mode: Logical parallel with COM0
Use USB Com Port as COM2 --> yes or no ???
COM3 mode (USB-COMFSK): Mode-10, Baudot-RTTY
Radio RRC settings:
Radio: 38400 baud and program mode 10
Serial settings: COM1 mode: inactive ?? or something else
COM2 mode: Logical parallel with COM0
thanks very much for you expertise and guidance. Need clarification for 3 questions above
Fred, VE3PIE
-
Fred,
Leave COM0 and COM2 as NO, otherwise it won't work.
COM1 for CAT is your decision: you can use either a normal serial cable (NO),
or choose to load the USB driver and use the USB cable (YES).
73,
Mitch DJ0QN / K7DX