Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: w4rdm on 2010-04-16, 20:55:07
-
What is the bandwidth required for the Kenwood TS-480 and TS-2000 to operate properly with Remoterig RRC-1258MkII?
I have a Verizon 3G usb modem that I want to use.
TNX,
Ron W4RDM
www.hexkit.com
-
Hi Ron,
the bandwidth depends on the settings. Maybe this listhttp://www.remoterig.com/en/codec.htm (http://www.remoterig.com/en/codec.htm) helps.
I don't use a TS-480 or TS-2000 but with my IC-706 and default settings for the codec I have around 210kbit/s.
vy 73, Simon (DJ4MZ)
-
Simon,
TNX for the link. That was exactly the information I was looking for.
73,
Ron W4RDM
-
Hi
The lowest audio codec needs 80kBit/s and then the control channel needs bandwitdh when rotating the VFO so 128 -256 kbit/s is good to have available
Remember that you need a router between the USB-stick and Remoterig boxes
73 de mike
-
I have a Cradlepoint PH300 router that I have been using with the usb stick.
The router also has a battery built in for portable use.
73,
Ron W4RDM
www.hexkit.com