Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: Andreas on 2010-05-05, 20:27:49

Title: TTL connector and 8V
Post by: Andreas on 2010-05-05, 20:27:49

Hi all,
i got my RRC1268-MK2 yesterday.
I tried to measure the 8V at the 6pin TTL connector at pin 2. But there is no voltage present.
At the website there is mentioned, that the 8V are always active. Whats going wrong ????
73
Andreas, DL5MGD

Title: Re: TTL connector and 8V
Post by: sm2o on 2010-05-06, 03:13:23

Hi

If the 8V are there depends on which mode the RRC is set set to. If you should connect to it you probably will use TS-480 then set radio mode to TS-480 and the 8V eg 9V will be switched on

73 de mike