Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: DH8AAA on 2014-02-02, 19:17:28
-
Hallo,
I upgrade my IC-7100 control Unit (with W-LAN modul ) to Firmware 2.76.
After ca 5-10 minutes the Controller restarts, then it works for ca 5 minutes and restart again..... and so on.
After downgreat to 2.75 the unit works fine.
73
Oliver
-
That does not sound too good ;)
Does it restart even if the controller is not connected to the radio RRC?
Are you using the WiFi connection? If yes, did you try using Ethernet(wired)?
-
I use the WiFi with my IC-7100.
I donīt know if the controller restarts or lost WiFi connection.
My TS-2000 with Lan connection works fine with Firmware 2.76.
73
Oliver
-
Now i have update my TS-480 equipment (with WIFI) to 2.76.
It works fine too.
73
Oliver
-
I see. Do you use the same WiFi access point for the TS-480 and the IC-7100 equipment?
-
Yes, it is the same.
-
Can you check "Uptime" on the "Info" page and see if it resets(=gets a lower time than before the "restart")? If Uptime continues to increase even after the "restart" then the RRC is not rebooting itself.
-
The new FW 2.77 solves my Problems.
Manny thanks for the good support.
73
Oliver
-
Great! We thought it would, but wanted to have you confirming it since you had problems. :)
-
Hallo Jan,
i have downgreat to 2.76 and the Problem is back.
After 3 mins uptime the box restart. The uptime Counter beginns new.
73
Oliver