Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: Mike/K3MMB on 2010-06-11, 18:02:09
-
I am using the remote on the internal network, before I Move it to the internet.
My setup is 706 radio connected to router via cat5
contol head connected via linksys ethernet wireless bridge using DHCP. Heil hedset and standard hand mic with motorola speaker.
It seems that the volume both on the headset and the speaker is low. I have to increase it by using the control head dial.
Is this a normal situation or perhaps due to my setup?
It is a great system, however and I do enjoy the ability to move around the QTH.
74
Mike
Things seem to work but it seems to me my
-
Hi
if you set the switch behind the control panel to speaker mode ( not headset mode) and connect the speaker to the frontpanel jack you should have exactly the same level to a 8 ohm speaker as if you connect the frontpanel direkt to the radiobody without the remoterig system. At the RRC frontpanel speaker jack you have always that level and are not depending on the speaker/headset switch
73 de mike
-
Thanks Mike,
The connection on the 1258 is a very good output.
I appreciate your help.
73
mike