Remote Rig
RRC 1258 Support in English => Hardware, Cabling, Installations => Topic started by: W1UE on 2014-08-05, 03:09:48
-
I'm going to the Remote site tomorrow. I've been looking at what's available in firmware at the RR Box there, and I don't see any clear way to do this.
My desire is to key the K3 via the rear panel KEY jack connected to the Remote Rig box when I want to use the Remote Station, and to key the K3 via the RTS/DTR lines via N1MM when I am using it locally. In this manner, I don't have to switch any cables when going from Remote to Local usage.
How can I set up the Remote Rig box to do so? I think I see how to do it at the Control end, but I want to do it at the Remote end and I don't see the firmware options that will allow me to do so.
Dennis W1UE
-
There is only one way to key the radio from the radio RRC, it's to connect a cable from the PAD or I/O jack to the straight key input. At the control-RRC you can use several ways, one is the RTS/DTR line as you say.
If you want to use the Radio locally just put a splitter on the straight-key input behind the radio, then you do not have to change cables
73 de mike