Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: ea3in on 2010-07-23, 10:25:44
-
Hello
I'm not able to put my PC Client in working order.
Probably I don't understand its behaviour yet
Software is installed without errors in one of my laptops (except that Location doesn't show microbit)
I have only set up the SIP part, because I plan to use it only for audio and PTT.
FIRST QUESTION: Is it mandatory to have a COM setup in order to establish a SIP link?
SECOND: My radio is a TS-480. Is it mandatory to use it via the serial port? So is it mandatory to have 2 connections: one serial ant the other with standard cable I use when using the remote RRC?
I will come with more questions. Sure
Thanks in advance
-
Hi
Yes you have to setup a serial port also. You do not need to use it, but if there is no data traffic the connection will be disconnected after about 5 min.
If you want to control the TS-480 from HamRadioDeLuxe(HRD) via the MicroRRC you must use the RS232 port on the TS-480. HRD can not handle the control panel protocol.
73 de mike
-
Now working on this laptop
Thanks