Remote Rig
RRC 1258 Support in English => Hardware, Cabling, Installations => Topic started by: w1ve on 2015-03-21, 18:18:01
-
Lots of documentation on using Pings 4 and 8 of the IO connector for CW.
I've tried two old RJ45 cables... Pin 8, Ground, is brown, and Pin 4, the key line, is Blue.
Anyway, when I connect the two, nothing happens.
I am running a standard RRC box set for a K3, and the Remote is a K3. I have set my own jumpers. Everything works wonderfully, other than this.
Could a jumper be set wrong? THe CW Paddle input, as well as the dot/dash pins on the I/O port, work fine.
Frustrated!
73, Gerry W1VE.
-
Gerry, did you change IN0 mode to keyer as on page 95 of the manual?
The important pages are pages 94-95 and appendix B.
73,
Mitch DJ0QN / K7DX
-
Thanks Mitch!!
That was it, of course!!