Remote Rig
RRC 1258 Support in English => Hardware, Cabling, Installations => Topic started by: K1UO - Larry on 2015-11-07, 22:34:06
-
Does anyone know which pins to connect up on RRC COM1 port to use with the SPE2K. Is it 2,3 and 5 or 7,8 and 5? It looks like SPE uses 7,8,5 on their end for Remote control. Chances are it is 7,8 and 5 but not 100% sure.
Larry K1UO
-
Larry,
That is correct, SPE uses pins 7 & 8 instead of 2 & 3, since those pins are used for SteppIR control.
73,
Mitch DJ0QN / K7DX
-
Here are the instructions and cable drawings
http://www.remoterig.com/wp/?page_id=426#tabs-2
73 de mike
-
Got it and thanks for the instruction sheet..Had not seen that before. Should be good to go now.
Larry K1UO
-
Thanks for posting this - just what I needed! Steve