Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: n0ac on 2016-01-21, 04:33:55

Title: received CW very choppy
Post by: n0ac on 2016-01-21, 04:33:55

I got the control remote to power up the remote.

Now when I listening to CW it is so choppy it is hard to copy calls. I'm sure there are some settings but which one(s).

Bill, N0AC

Title: Re: received CW very choppy
Post by: sm2o on 2016-01-21, 14:04:44

Hi
Increase "Key delay ms [0-250]" start with 50 and check if it's OK

73 de mike

Title: Re: received CW very choppy
Post by: n0ac on 2016-01-21, 14:57:26

It is already set to 50 ms. I assume you were talking about the setting in the keyer settings menu.  I made not have made myself clear. The problem is receiving the CW not in sending.

Bill, N0AC

Title: Re: received CW very choppy
Post by: sm2o on 2016-01-21, 15:05:24

The RRC do not know if you are listen to CW or Phone, it just transfer the audio so it was tricky to guess you really mean receive.
To increase the tolerance against jitter when receiving, increase the jitter buffer size and jitterbuffer delay in the Control-RRC
Check the manual for details.

73 de mike

Title: Re: received CW very choppy
Post by: n0ac on 2016-01-21, 18:52:05

I think this is more of a connection problem. In the middle of today RX is very good. My problem yesterday was in the evening and probably lots of traffic.

Thanks for the answers to my concern.

Bill, N0AC