Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: K7FL on 2016-02-12, 02:23:51
-
I have my Elecraft K3s communicating effectively over the LAN and am now attempting to connect over the Internet. I have enabled port forwarding on my firewall for 13000, 13001, 13002, and 80 and the RRC shows "Idle" status (see below). However, the K3s still gives a congestion tone when turned on. Everything is physically connected as normal but the AUX/MIC shows no link or activity lights.
Any pointers would be appreciated.
Here is the status from my control RRC:
Name Value
Control panel ON
Radio OFF
Connection status Disconnected
SIP status Idle
Last SIP error None
RTP/UDP audio status Disconnected
UDP cmd status Disconnected
SIP command timeout 0
Rx Jitter buffer size 4
Rx Jitter delay 3
Dual Rx 0
SIP Out port 13000
SIP In port 13000
Audio Out port 0
Audio In port 0
Command Out port 0
Command In port 13002
External SIP In port 13000
External Audio In port 13001
External Cmd In port 13002
Other party 0.0.0.0
Input 0 High
Input 1 High
Input 2 High
Output 0 Low
Output 1 Low
Output 2 Low
DNS status Unknown
Active profile Profile 2
PTT status OFF
Common network settings Yes
-
Did you change the SIP contact to the external IP address or dynamic DNS address? Is the control RRC using DHCP now that it is in a different network?
73,
Mitch DJ0QN / K7DX
-
Yes, we changed to the external IP address. The control RRC is not using DHCP but we did change the IP address to the correct subnet so it is visible on the local network.
-
The control RRC says:
DNS status Unknown
If you are using a host name as SIP contact then it will not be able to look-up the radio RRC's IP address.
-
We used the actual IP address.
More suggestions welcomed.
Thanks
-
Solved! I had forgotten to enter the SIP password. So obvious !!! :o
Thanks
Dennis, K7FL
-
;)