Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: dl5cg on 2016-03-22, 17:25:59
-
Hello User,
at the moment I have trouble with the CW keying on my TS480SAT.
Has anybody a config example file for keying ? Is it useful to chance any
parameter in the TS480 menu too ? But i think the keying process is only to
set in the control box ? The keying sound is now very hard and smeared. It was
clear earlier.
Many thanks for a good idea :'(
Here can you see my actual keyer settings : http://www.dl5cg.de/aktuell/
73 Andreas DL5CG
-
Andreas,
Here is my CW checklist:
CW Checklist
------------------------------
on the radio RRC:
- under keyer settings, set PTT activated by keyer to YES
- under I/O settings, change OUT2 mode to KEYER
on the control RRC:
- under keyer settings, set enable to YES
- change other keyer settings as desired
- under I/O settings, set IN0 mode to KEYER
Make sure that the cable is connected between the radio RRC and rig's key (NOT paddle) jack. If possible,
use a mono plug on the rig side, since stereo can cause problems under certain situations (e.g. FSK).
73,
Mitch DJ0QN / K7DX