Remote Rig

RRC 1258 Support på Svenska => Allmänt diskussionsforum => Topic started by: N8MW on 2016-10-31, 02:15:25

Title: UDP command status error(0) impact
Post by: N8MW on 2016-10-31, 02:15:25

I am getting the UDP command status error.  Possibly because it's not enabled in WiFi connection.  I am using the RRC for audio and PTT only.  Will the error affect operation for these functions?

Title: Re: UDP command status error(0) impact
Post by: dj0qn on 2016-10-31, 04:09:29

Did you forward all three UDP ports?

73,
Mitch DJ0QN / K7DX

Title: Re: UDP command status error(0) impact
Post by: N8MW on 2016-10-31, 18:06:36

No, I don't need UDP control I'm only interesed in whether or not it will affect audio or PTT.

Title: Re: UDP command status error(0) impact
Post by: dj0qn on 2016-10-31, 18:10:11

You absolutely MUST forward all three ports! Otherwise, nothing will work, including audio!

73,
Mitch DJ0QN / K7DX

Title: Re: UDP command status error(0) impact
Post by: N8MW on 2016-11-01, 03:55:08

All those ports are forwarded, but I still get the UDP command status error(0).  What can cause this error?

Title: Re: UDP command status error(0) impact
Post by: dj0qn on 2016-11-01, 03:58:48

You would get that error if the a port is not forwarded or blocked. Also make sure that SIP ALG
is turned off.

If you send me a short mail to dj0qn (at) darc.de, I can send you my networking checklist that
may be able to help you.

73,
Mitch DJ0QN / K7DX