Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: DL2BP on 2011-01-02, 01:15:38

Title: update firmware V 2.30
Post by: DL2BP on 2011-01-02, 01:15:38
Hello,

i make my first steps with the RRCīs and i have problems to update the firmware.

I have connection via USB and can read the info, that i have V 2.28.

By starting the update (.bin-file was located on my PC), after a few seconds i become an error message: ...writing failed.

Any idea please?

73

Kai
Title: Re: update firmware V 2.30
Post by: Chris DL5NAM on 2011-01-02, 09:03:22
Hello,

did you using: Application firmware upgrade ?

Test: reload again the new file try again

73 Chris
Title: Re: update firmware V 2.30
Post by: DL2BP on 2011-01-02, 13:13:33
Hello Chris,

yes i did.

From a company i became following answer: using the webinterface, the same stands here in the forum.

But today, i am not shure how to make this.

73

Kai
Title: Re: update firmware V 2.30
Post by: Chris DL5NAM on 2011-01-02, 18:41:24
Kai,

did try http://192.168.0.227 and/or 192.168.0.228?

73 Chris
Title: Re: update firmware V 2.30
Post by: DL2BP on 2011-01-02, 23:09:27
Hi Chris,

after reading the chapter of the webinterface: success


tnx

73

Kai
Title: Re: update firmware V 2.30
Post by: Jan (Microbit) on 2011-01-03, 11:03:09
We have found an issue in version 2.28 which sometimes causes firmware update using USB either to fail or to falsely give an error message stating that the update failed. This is fixed from version 2.29. If you get an error message when updating 2.28 via USB, then check if the update was done despite the error message, and if it actually failed then update using the web interface(Application upgrade).