Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: hb9gce on 2011-01-07, 06:05:39
-
Hi All
After succesful installation of my remoterig, when I try to trasmit on CW with a paddle I have only the local sidetone, I can't transmit. Is this do to the wrong remote connection to my ts480, "straight key" jack instead of "paddle" jack ?
73s de HB9GCE
Andy
-
Hi Andy
Switch on the vox on the transmitter and you will be happy... Connection at the transmitter has to be done via manual-key input, the remoterig-box has a built in electronic keyer that acts like a manual key.
73 de Mark, HB9AZT
-
Hi Mark
Done, nothing, also with VOX activated. Have I forgotten some settings in the ts480?
73s de hb9gce
andy
-
Hi
I hope you maked a stereo plug for cw connection to remote site.
After this you must set the keyer , for iambic ,and also the I/O menu the correct I/O out as keyer
Hope that this may help you
73 de George
sv1elf
Hi All
After succesful installation of my remoterig, when I try to trasmit on CW with a paddle I have only the local sidetone, I can't transmit. Is this do to the wrong remote connection to my ts480, "straight key" jack instead of "paddle" jack ?
73s de HB9GCE
Andy
-
Hi George
Yes, in fact the settings were wrong, now alla OK, thanks !
73 de hb9gce
Andy