Remote Rig

RRC-Micro PC Client in English => General discussion => Topic started by: WB4KSP on 2019-09-07, 01:59:44

Title: Help with FT8 mode and Kenwood 480hx RCC1258 hookup for home. How to hookup?
Post by: WB4KSP on 2019-09-07, 01:59:44
I'm using a RR RC1258 2 box system one at the remote, one at home QTH.  The remote head is connected to the remote RCC1258 and all is working fine for SSB communications.  I now want to hook up my PC to the 480 / RCC1258 480 Head.  How do I do that?  I use one USB cable with my ic7300 and it works fine with the WSJT and JTAlert software.  Anyone have a checklist to help?

Tx
73
WB4KSP
Title: Re: Help with FT8 mode and Kenwood 480hx RCC1258 hookup for home. How to hookup?
Post by: dj0qn on 2019-09-07, 12:44:43
Here is my checklist for TS-480 CAT:


CAT CHECKLIST
---------------------
IMPORTANT: In both scenarios, you MUST first install a standard serial cable between the TS-480 body and COM2 of the radio RRC!

USING A STANDARD SERIAL CABLE
============================
1) Change the CAT rate on the TS-480 to 4800 baud (menu 56). This rate keeps traffic over the internet to a minimum and faster is not necessary for CAT.

2) Change the COM2 serial settings of the radio-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.

3) Change the COM2 serial settings of the control-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.

4) Plug a serial cable in between your PC and the control-RRC COM2

5) Set your software to use the correct COM port on your PC at 4800-8-1-N

USING A USB CABLE
=================
1) Change the CAT rate on the TS-480 to 4800 baud (menu 56). This rate keeps traffic over the internet to a minimum and faster is not necessary for CAT.

2) Change the COM2 serial settings of the radio-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.

3) Install the Microbit Setup Manager if you already haven't. You don't need the problem for this, but this installs the correct drivers on your PC.

4) Change the COM2 serial settings of the control-RRC to mode-4, 4800 baud, data bits 8, stop bits 1, "use USB Com Port as COM2" to "Yes" and submit/apply changes.

5) Plug a USB cable between your PC and control-RRC. Make sure you do NOT do his before step 3 above!

6) Find out the correct port in your Windows Device Manager to use by looking for the "Microbit RRC Virtual COM Port (COM2)"

7) Set your software to use the this COM port on your PC at 4800-8-1-N.

Note that this has been posted several times, so you could  have found it before had you used the search function of this forum.

73,
Mitch DJ0QN / K7DX