Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: MW0NRE on 2021-01-24, 20:23:53

Title: Will the control & radio remote rigs connect to each other if there's no radio?
Post by: MW0NRE on 2021-01-24, 20:23:53

Just doing the initial setup and thought I'd check that the remoterigs were connecting but I'm seeing Disconnected, is this expected with no radio gear attached, or have I done something wrong?

Niamh

Title: Re: Will the control & radio remote rigs connect to each other if there's no radio?
Post by: dj0qn on 2021-01-24, 20:30:57

Niamh,

Mike may wish to confirm, but I am very sure that it can not connect without a rig.

73,
Mitch DJ0QN / K7DX

Title: Re: Will the control & radio remote rigs connect to each other if there's no radio?
Post by: MW0NRE on 2021-01-25, 09:21:30

Thanks Mitch, I was trying to proceed in small steps checking each stage.

Niamh

Title: Re: Will the control & radio remote rigs connect to each other if there's no radio?
Post by: sm2o on 2021-01-25, 14:20:48

Hi

both files are from the control-rrc

in ft-857 mode it will not work without a radio as PWR-ing on the frontpanel is initiating the connection

modes where there is a connect button on the status  page will work without a radio

73 de mike

Title: Re: Will the control & radio remote rigs connect to each other if there's no radio?
Post by: MW0NRE on 2021-01-25, 15:16:47

That'll teach me to rush! Correct radio config attached.

Will try a different mode to test that the remoterigs are communicating

Niamh