Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: oh2xx on 2021-11-29, 14:51:52
-
Hi,
We had a mysterious problem at OH0Z. SSB stopped working without any warnings. Tomi (OH6EI) visited the station now during the cqww and we had time to check the problem as we thought it would have been just a loose connector or a faulty cable. But it was not. Luckily we had an older RRC there (that we replaced for other reasons) and SSB started work with it just fine. So there is something wrong inside the RRC as rebooting did not help and the FW is the latest. Tomi will bring it back for further investigation but I do not know what to do with it next - any ideas?
73 de Kari, OH2XX
-
Hi
check the codec gain settings.
73 de mike
-
Thanks for a prompt reply Mike! Tried that too but set it only to 10 as I thought it would be a 10 dB increase. But in the old (and the one that is currently in use) the codec gain is 255... So that is something to test for sure.