Remote Rig
RRC 1258 Support in English => Hardware, Cabling, Installations => Topic started by: lx1no on 2021-11-30, 20:34:36
-
Hello,
After some surgery and being restricted to stay at home, I finally set-up my RRCs in my local network today using an IC-7100. Seems to work, except for CW which apparently needs an additional cable from RRC-Control to the rig when using the built-in keyer. Now, the 7100 does not have an exceptional receiver. Is there any possibility to use an IC-785x as backend? Or an IC-7300? If so, what must be done/is needed? Having lots of time currently, so thinking a bit further.. Any comment appreciated.
73 Norby
-
Just configured mine yesterday and having the same issue. Any luck? I am usig ic7100 as well, it appears as if it is working properly on the control side but radio is not sending.
Thanks
-
Finally found out how to enable CW keying on an IC-7100 that's linked via 2 RRC devices: On the RRC-radio side, go to IO settings and select "Keyer" in OUT2 mode.
In addition, set the CW side-tone generated in the RRC-control to something like 45 in the Keyer settings / Side tone -db box.