Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: dd0ul on 2022-02-05, 13:36:49
-
Moin,
I am still setting up my remote station, the devices are still next to each other on the table in the same network. I was done with the jumpers and the wire bridges, CW and microphone were already working last week.
Today I wanted to continue, but the TRX can no longer be switched on.
Troubleshooting:
The two RRC1258MkII are connected (using autoconnect)
Shack-Side:
Status
Name Value
P5.4 ON
Radio OFF
Connection status OK
SIP status Connected/transfering
Last SIP error None
RTP status Excellent(60)
UDP cmd status OK(20)
Radio-Side:
Name Value
P5.2 OFF
Connection status OK
SIP status Connected/transfering
Last SIP error None
RTP status Excellent(60)
UDP cmd status OK(45)
That brings me to the first question: What does this P5.2 stand for? It's off.
If I try to turn on the TS480, nothing happens. If I pull off the 6-pin cable to the control panel and connect it to the 6-pin cable on the TS480 itself using an adapter, the TS480 can be switched on and off. Then even the microphone works - that is, via the SIP connection.
When I connect the 6-pin cable from the RRC 1258 MkII radio to the TS480, I hear a faint click in the TS480 control panel.
But that's all. Am I doing something wrong? Have I forgotten something important to do since last week?
Thanks for hints.
vy 73 de Micha, DD0UL
-
Hi
Auto connect should be off,
If p. 5.2 shows off the 6 pin cable is bad
73 de mike
-
Moin Mike,
thank you for the information.
In advance: the cable was actually broken. I thought, I had ruled that out, since I had connected the two cables with the help of an Ethernet extension adapter - which then worked. But: after I exchanged the cable on the TRX side with another one, it works. I do not have to understand everything ;-)
vy 73 de Micha, DD0UL