Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: ea1x on 2022-07-01, 00:16:22
-
Hi all …
Here trying to configure it.
1st at all, factory reset of control rrc was needed due to previous pwd. Configure it, install all cabling and try to power on, k3/0 “lights on” but, no conection sound and k3 remains off.
Checked status Booth rrc seems to be connected, I can see other party local ip and both mac.
Both k3 and k3/0 same fw version.
Suspect wrong rrc control conf. After factory reboot. Perhaps in i/o on/off config???
Help needed … any suggestion will be welcome
Tnx a lot in advance
Juan EA1X (EF1A) sends
-
Hi agn ...
I continue with trials and, not so good. Remote K3 still not goes ON :-(
Checked all parameters and conetions in remote K3 and both RRC following elecraft manual, It seems be ok.
When start k3mini, both RRC recognize another one IP and mac adress so, seems they're interconnected
my config attached as follows. can anybody pse check it?
tnx a lot in advance.
Juan EA1X (EF1A)
-
it does not look correct send export setting(html) files from both units
73 de mike