Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: va3mw on 2011-05-30, 21:30:25
-
In my setup, I have the following.
TS-480
Com 1 is my Elecraft W2 Wattmeter
Com 2 is my LP-Remote control board for the remote site.
Am I correct in reading that at the control head end, that it is possible to connect the radio to the computer for HRD as example, but that I would have to give up Com 1 or Com 2 to do it?
73, Mike
-
Hi
Yes there are only 3 serial ports
73 de mike
-
Yes, there are only 3 serial ports, but can I access Com0 via USB on the Console end?
-
Yes, there are only 3 serial ports, but can I access Com0 via USB on the Console end?
No, only Com2 can be accessed via USB. Might change in the future though.