Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dave4e

Pages: [1]
1
General discussion forum / Three mobile internet UK
« on: 2013-02-18, 12:44:59 »
Hi
Anybody successfully using Three mobile internet in the UK, i keep getting a SIP error, Vodaphone works ok.
Regards
Dav e

2
Configuration of Routers, Firewalls, etc / Port Testing
« on: 2012-12-29, 12:41:11 »
Hi All

Here is a link to a very handy Web page that has some very good Port forwarding guides, examples and simple testers.

If like me, your not too familure with how to Port Forward then this is a good place to start for some info, I found it difficult to know if it was me, the RRC or my Router that was causing the problems, the forum and tools make it a lot easier, in the end ive found that it is the router that is at fault.

http://www.pcwintech.com/tools

Dave 


3
Configuration, RRC 1258 / DESPERATE!
« on: 2012-12-16, 18:15:05 »
Hi All

Ive been playing about with this RRC for about 6 months now and have NEVER managed to connect from outside my own network, ive been trying again recently, but no mater what i do i cannot get the ddns to update when i check it at http://www.remoterig.com/wp/?page_id=1481

Can anyone help.

Im using the following

Icom IC706mkii ( works fine on my LAN)
ISP talktalk
router Huawei HG520b
Product 1258
Serial number 2066

I saw an earlier post about problems with early serial numbers? could this be it.

Someone please help as im about to give up once and for all.

Reagrds
Dave EI4HT / M0GIW

4
Hi All

Im having lots of problems getting my system to work, I currently have no access to internet other than my 3G dongle and home internet.
I have been unable to get the RRC to connect from 3G. the orange light on the control RRC flashes and i get the error tone.

Everthing within my LAN is ok.

Ive checked http://ddns.remoterig.com/status and my IP is not updating? ive set the radio RRC to 10mins and restarted the box but nothing so far. do these accounts lockout like dyndns does?

I am able to access the Radio RRC Web server using 3G but am unable to turn on my IC706, ive been manually entering my routers external IP address to do this, as the external IP is no longer updating as above.

I also have a few other questions, Please bear with me as i am no networking expert.

I am able to use http://canyouseeme.org/ to see if the ports on my router are open.
I can see port 90 ( webserver ) as open but none of the others, should i be able to see the UDP ports open?

Am i missing something obvious? Im using www.three.ie for my 3G connection.

Not having another network to try and test from is not helping troubleshooting.

Regards
Dave

 

5
Hi All

Ive been trying without success to share WiFi or 3G from my Win7 Laptop to RRC.

Im able to share internet from Laptop rj45 to another laptop but am unable to get RRc to connect when using Wifi within my LAN or 3G when outside.

Also this might seem like a silly question but how do you connect to the control RRC when at a remote site to adjust parameters?

Regards
Dave

6
Hi All

HAs anyone experience of sharing 3g to laptop ethernet port on Win 7 ? im a wee bit lost ...

Regards
Dave

7
General discussion forum / IC 706 MK II Power Up ?
« on: 2012-05-28, 19:05:23 »
Hi All

My first post so hello all,

I recently bought a second hand RRC 1258 MK ii to use with my IC 706 MK ii

Not having much success and wonder if anyone can help.

Ive setup both radio and control RRC's as per the manual, ive made the cable and tested it and it works ok. 

Ive connected both RRC's to my network and can ping them and open the web browser no problem

When i connect the control head for the IC 706 MKii and press the power button i can hear the relay in the Radio click, then drop put again, the control head does not power up.

Ive checked the jumpers and all is correct although i did find that some of them broke easily.

Ive tried different power supplies at the control end and this has not worked.

Can anyone suggest something else i may have over looked or a method of testing ive not tried?

Regards
Dave EI4HT / M0GIW

Pages: [1]