Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - HB9ODP

Pages: [1]
1
Hi, anyone use the Palstar HF Auto Tuner with Palstar HF Auto-R (remote RS232 unit) 'over' remoterig?

73
HB9ODP Mattia

2
Configuration, Webswitch 1216H / Upgrade vs 1.7, How-to?
« on: 2014-02-07, 17:01:38 »
Hello, I'm interested to upgrade the firmware to vs 4.0 of my old WEB Switch 1216H, but with the browser I have always this error (with IE / Firefox / Chrome):
Wrong file type, got 37, expected 36
Double checked and the firmware is for this unit. Redownloaded the file...
"1216H_WebSwitch-CRC-NEW_Ham_v4.0_2013-10-18.bin"

Checked also with vs 2.9, same...

So installed the setup manager 2.5 and used the USB cable; same as above... Invalid file content.

Serial nr of this unit: 1418

System info:
Company : Microbit
Product : 1216H Web Switch
Software: 1.7
Hardware: 1
Build   : Apr 22 2010 16:20:03
S/N     : 1418
PID     : 4

Thanks for any help :-)

Regards
HB9ODP


3
Hello, any wiring diagram for connecting a Kenwood V71 / D710 to a RRC V1?
Mic wiring it's like a Kenwood TS480 (with reverse RJ45 numbering), but the display?

RDO = RXD?
TDO = TXD?

Software setting (baud rate etc)

On wiring diagram in RRC V2 I see 10V for the display... in RRC V1 8V, but maybe this is not a problem.

Thanks for any info / experience

4
Hello, it's possible to read a string with an internal http page to know if the relais are ON or OFF?

5
Inspired from RRC v2 and tired of the double wire microphone / display (my was very delicate), I made an internal modification.
I used the rear DB9 connector for the display and the front AUX RJ45 for Kenwood original microphone.
Better solution.

Some detailed photos:
http://www.hb9odp.ch/index.cfm?page=photo&subpage=List&Cat=25


6
General discussion forum / RRC behind 3G / UMTS
« on: 2009-11-16, 15:22:13 »
Anyone use this remoterig behind 3g / umts mobile network? What's your best config for audio codec / jitter etc.?

7
General discussion forum / Rear I/O and remote button
« on: 2009-11-15, 19:40:43 »
Hello Mike, I think is really possibile to use the rear I/O port to 'short' a remote button. Maybe with the same OPTO coupler for PC CW Keying? The idea is to 'remote push' the TUNE button on my MFJ automatic tuner.
To be checked, not sure, but I think when I push TUNE, the button is grounded.

8
General discussion forum / SSH Support?
« on: 2009-11-02, 16:35:27 »
Hello Mike, this unit it's linux embedded? There is a SSH support to open a Tunnel?
It might be an interesting solution to open only one safe port in the firewall / NAT for configuring the unit, use your webswitch or other network devices

Pages: [1]