Show Posts
1
General discussion forum / Expert 2K-FA remote control via RRC RS-232
« on: 2014-10-26, 13:00:07 »
Hi all,
Good news;
The main issue is now solved and remote with RS-232 via RRC boxes is working well. It was not RRC configuration or cabling, it was the Term_2k_232.exe SW which was not supporting lower speed than default 115200Bd - After got enhanced version of this terminal SW, all started to work. Main point was to be able to get the baud rate set to in a way that also RRC can manage. It seems to work also with 9600 well - Now its time to do fine tuning for the set up.
Thanks to all who supported me on this journey!
**********
Hi all,
Just checked older postings but did not find answer how to get 2k-FA cabled with RRC and if there is any need for config changes on RRC or/and amplifier? So, wiring schema and possible config settings would be nice to have.
I tested local remote with USB and it works nicely.
I tested also locally with RS-232 SW and it works OK.
With RRC boxes I cannot get it working. Now, it seems to be cabling issue or configuration (or both...)
Also wondering if the comms speed can be changed (default is 115200Bd). I have not found any menu for this. There is some menu for other port functions/speed but not for this RS-232.
All advices to get this remote working are very welcome?
You can contact me also directly: oh2ma@phnet.fi
73 de Jukka - OH2MA
Good news;
The main issue is now solved and remote with RS-232 via RRC boxes is working well. It was not RRC configuration or cabling, it was the Term_2k_232.exe SW which was not supporting lower speed than default 115200Bd - After got enhanced version of this terminal SW, all started to work. Main point was to be able to get the baud rate set to in a way that also RRC can manage. It seems to work also with 9600 well - Now its time to do fine tuning for the set up.
Thanks to all who supported me on this journey!
**********
Hi all,
Just checked older postings but did not find answer how to get 2k-FA cabled with RRC and if there is any need for config changes on RRC or/and amplifier? So, wiring schema and possible config settings would be nice to have.
I tested local remote with USB and it works nicely.
I tested also locally with RS-232 SW and it works OK.
With RRC boxes I cannot get it working. Now, it seems to be cabling issue or configuration (or both...)
Also wondering if the comms speed can be changed (default is 115200Bd). I have not found any menu for this. There is some menu for other port functions/speed but not for this RS-232.
All advices to get this remote working are very welcome?
You can contact me also directly: oh2ma@phnet.fi
73 de Jukka - OH2MA