Show Posts
1
Configuration, RRC 1258 / Problem with Setup FT817 with HRD
« on: 2014-07-10, 06:47:17 »
Hi, I am a new owner of thr 1258Mk2S units.
I will be living 50% of my time in Bangkok, and the other half at home at VK4. I am setting up to have fun from BKK in what little spare time I will have.
I have set the pair up for Mode 3 FT8x7 etc strapped appropriately and have communication. Audio, Mic PTT etc all work. All good so far.
I wish to use HRD to control the 817. I am having no luck connecting
I have used a usb>rS232 into com2 on thr Cont unut
II have also tried setting USB>com2 and using the usb cable. Same results.
I have run setup to get the Virtual Com ports appearing. Tried them all esp the one mapping to Com2. No Luck.
Settings attached
Cheers
Ken VK4GC
HELP I leave for BKK in 8 days.
I will be living 50% of my time in Bangkok, and the other half at home at VK4. I am setting up to have fun from BKK in what little spare time I will have.
I have set the pair up for Mode 3 FT8x7 etc strapped appropriately and have communication. Audio, Mic PTT etc all work. All good so far.
I wish to use HRD to control the 817. I am having no luck connecting
I have used a usb>rS232 into com2 on thr Cont unut
II have also tried setting USB>com2 and using the usb cable. Same results.
I have run setup to get the Virtual Com ports appearing. Tried them all esp the one mapping to Com2. No Luck.
Settings attached
Cheers
Ken VK4GC
HELP I leave for BKK in 8 days.